NETWORK CONFIGURATION

Here i'll tell you about configuration of network.. For Configuration of network we make a Logica design about the topology..Mostly while when we connect the computer with networking Switch it look like the star topology.So in Network Configuration we have to install network devices like Switch and Hub..This type of installation are in Local are network.. We connect the Computers with Switch and Hub..Now we have to discuss about the configuration of network devices..In local area Network we connect the computer's with switch and switch with router(router is also a networking device).. In configuration of devices we use protocol's for communicating with each other.. Steps of Configuration for Local area network.
1)Access The Router(with any software)
2)Enable the router.Select the port on which you set an IP. Give an IP to the port according to the        requirement.
   (IP class and subnet mask .That IP is Local IP)
3)Exit form the step.
   (exit form the current step to perform other step)
4)Configure The Protocol.
   (There are different type of  Protocols to stepup a network)
Configuration for Wide area network.
Follow the same step
 5)Give An IP Private IP
    (which is routeable)
6)same configure the protocol

The red sign show that no One IP is given and not a protocol is configured.
And green sign is atuomatic powered on because when wo connect computers with switch with wire it will start communicating.